Search:

Type: Posts; User: grey goose

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    806

    most blackmans are a bit squirrely at low speeds,...

    most blackmans are a bit squirrely at low speeds, I find that putting the trim tabs all the way down helps with this. when cruising in no wake zones.
  2. Replies
    1
    Views
    355

    Outer banks weight

    Does anyone know the weight of the outer banks model?
  3. Replies
    5
    Views
    2,442

    Thanks I will be getting out the multi meter.

    Thanks I will be getting out the multi meter.
  4. Replies
    6
    Views
    2,541

    I adjust my bennets a lot while running and find...

    I adjust my bennets a lot while running and find that putting them all the way down at low speeds to help with low speed wander.
  5. Replies
    3
    Views
    1,463

    I removed the original carpet and put down Sea...

    I removed the original carpet and put down Sea Deck came out nice, A bit hard to clean tho.
  6. Replies
    5
    Views
    2,442

    Starting issue?

    When attempting to start this Volvo Penta diesel I turn the key and nothing happens, The volt meter needle drops from 13 volts to zero then returns to 13 when the key is released, I did a load test...
  7. Thread: Wtb capstan

    by grey goose
    Replies
    1
    Views
    1,529

    I will have a Maxim 500 available when the...

    I will have a Maxim 500 available when the weather lets me remove it.
  8. Replies
    5
    Views
    1,986

    Cant believe that strap from the awning will...

    Cant believe that strap from the awning will support that boat.
  9. Replies
    8
    Views
    4,018

    Blackman shirts.

    A while back some shirts were offered and now they are getting faded and worn any chance that offer may come about again?
  10. Replies
    10
    Views
    4,844

    Nothing against the bill fisher but an 8'6" hull...

    Nothing against the bill fisher but an 8'6" hull seems a bit narrow to be running that high up, considering the weight that could be up there, Love the boat, Wish I had the cabin space, But trade...
  11. Replies
    2
    Views
    1,235

    I have found that the trim can be over ridden or...

    I have found that the trim can be over ridden or bypass the switch by taking apart the plug with the green and blue wires leading from the relays to the trim motor. use a jumper wire from the...
  12. Replies
    2
    Views
    1,235

    outdrive trim issue.

    Got the boat back in the water after having it torn apart and outdrive rebuilt. seems that the shift control needed to be recalibrated since I had to limp it to the slip, would not give more than 925...
  13. Replies
    8
    Views
    2,567

    Going to hoist it up Thursday and bolt it in. Its...

    Going to hoist it up Thursday and bolt it in. Its clean and painted and the bildge has new lights all wires cleaned up. lets see how it goes. Always fun dragging up a motor over a boat.
  14. Replies
    8
    Views
    2,567

    Yeah this one is the honey girl, The out drive...

    Yeah this one is the honey girl, The out drive has been gone through, It is a bunch of power back there but when running it can really get out of its own way. It has under gone a lot of upgrades...
  15. Replies
    8
    Views
    2,567

    Deisel install.

    When I pulled my engine I had torn it down pretty far so as to figure out how to get it out of there. Now that I am getting ready to put it back in I would like to reassemble it as much as possible...
  16. Replies
    10
    Views
    3,295

    Copy that I will go look. Thanks.

    Copy that I will go look. Thanks.
  17. Replies
    10
    Views
    3,295

    Volvo diesel parts.

    Looking for a parts source before I go off to the highest rate parts places.
    I need a "new" starter for my KAD 300 and a torque plate as well, Does anyone know the better route to aquire these items?
  18. Replies
    0
    Views
    833

    Blow by system.

    Did not like the Volvo system for emitting the oily blow by into the engine bilge.
    I sourced a racor CCV 4500 filter for it (since I could not fit a Walker air sep filter like I use on my work...
  19. Replies
    3
    Views
    1,808

    Shaft drive?

    Shaft drive?
  20. Replies
    1
    Views
    2,055

    Water tanks.

    Any one know off hand what the capacity of the fresh water tanks is on a 26 outerbanks? its a 2003. thanks,
  21. Replies
    3
    Views
    1,732

    Never hurts to flush things out. When I got my...

    Never hurts to flush things out. When I got my boat it had been well used. as in frequency but the after cooler was rotted out from salt. so while I had it out for repair I installed a sea strainer...
  22. Replies
    1
    Views
    1,161

    Nice.

    Nice.
  23. Scow is a term loosley used for a run down boat,...

    Scow is a term loosley used for a run down boat, But I think it actually refers to a flat bottomed flat ended utility boat.
  24. Replies
    0
    Views
    1,107

    Inner transom panel.

    Any one looking for or need to replace thier inside transome panel. it is the stock one from an outer banks.
    In ptetty good shape, requires about 9 or 10 screws to install. you may want to change...
  25. The trouble starts when your neighbors have scows...

    The trouble starts when your neighbors have scows sitting in the water nearby and hooked up to shore power.
    If they are using the wrong(read that cheap automotive) charger for thier batteries, or...
Results 1 to 25 of 45
Page 1 of 2 1 2