most blackmans are a bit squirrely at low speeds, I find that putting the trim tabs all the way down helps with this. when cruising in no wake zones.
Type: Posts; User: grey goose
most blackmans are a bit squirrely at low speeds, I find that putting the trim tabs all the way down helps with this. when cruising in no wake zones.
Does anyone know the weight of the outer banks model?
Thanks I will be getting out the multi meter.
I adjust my bennets a lot while running and find that putting them all the way down at low speeds to help with low speed wander.
I removed the original carpet and put down Sea Deck came out nice, A bit hard to clean tho.
When attempting to start this Volvo Penta diesel I turn the key and nothing happens, The volt meter needle drops from 13 volts to zero then returns to 13 when the key is released, I did a load test...
I will have a Maxim 500 available when the weather lets me remove it.
Cant believe that strap from the awning will support that boat.
A while back some shirts were offered and now they are getting faded and worn any chance that offer may come about again?
Nothing against the bill fisher but an 8'6" hull seems a bit narrow to be running that high up, considering the weight that could be up there, Love the boat, Wish I had the cabin space, But trade...
I have found that the trim can be over ridden or bypass the switch by taking apart the plug with the green and blue wires leading from the relays to the trim motor. use a jumper wire from the...
Got the boat back in the water after having it torn apart and outdrive rebuilt. seems that the shift control needed to be recalibrated since I had to limp it to the slip, would not give more than 925...
Going to hoist it up Thursday and bolt it in. Its clean and painted and the bildge has new lights all wires cleaned up. lets see how it goes. Always fun dragging up a motor over a boat.
Yeah this one is the honey girl, The out drive has been gone through, It is a bunch of power back there but when running it can really get out of its own way. It has under gone a lot of upgrades...
When I pulled my engine I had torn it down pretty far so as to figure out how to get it out of there. Now that I am getting ready to put it back in I would like to reassemble it as much as possible...
Copy that I will go look. Thanks.
Looking for a parts source before I go off to the highest rate parts places.
I need a "new" starter for my KAD 300 and a torque plate as well, Does anyone know the better route to aquire these items?
Did not like the Volvo system for emitting the oily blow by into the engine bilge.
I sourced a racor CCV 4500 filter for it (since I could not fit a Walker air sep filter like I use on my work...
Shaft drive?
Any one know off hand what the capacity of the fresh water tanks is on a 26 outerbanks? its a 2003. thanks,
Never hurts to flush things out. When I got my boat it had been well used. as in frequency but the after cooler was rotted out from salt. so while I had it out for repair I installed a sea strainer...
Nice.
Scow is a term loosley used for a run down boat, But I think it actually refers to a flat bottomed flat ended utility boat.
Any one looking for or need to replace thier inside transome panel. it is the stock one from an outer banks.
In ptetty good shape, requires about 9 or 10 screws to install. you may want to change...
The trouble starts when your neighbors have scows sitting in the water nearby and hooked up to shore power.
If they are using the wrong(read that cheap automotive) charger for thier batteries, or...