After all the work I've done on the deck, bait tank, and the rest of the boat, I still have water dripping into the bilge from the deck. The area I'm referring to is the aft part of the engine hatch where it meets the transome panel. There is a small channel or gutter (if you will) which allows the water to run off and into the side scupper area. Unfortunately the overboard discharge holes (scuppers holes) do not allow the water to drain fast enough and the water drips down into the bilge. Have any of you found a way to keep the water from dripping through there? My first thought is to just caulk it really well with 5200. Any better ideas? Not sure if this applies to the newer Billfishers. Tenacious is an 84' I'm determined to keep trhe bilge dry and the new engine rust free.