Calling Mike on the No Slack (and others)
My job to replace the impellers has turned into rebuilding the pumps. I installed the correct 'square ring' seals for the inlet and outlet pipes and confirmed these connections were not leaking. I raised the rpms and water started coming out of the vents. Looks like these seals are now bad.
I pulled one of the pumps apart and will get the rebuild kits next week.
1. What do you think of my parts? Can the shaft be repaired?
2. What type of greas do you use when you reassemble the parts?
3. Do I need a puller to remove the bearings from the shaft and a press to put them back on?
4. Does the drive pin need to be replaced?
I'd appreciate any reassembly advice you can pass along.
Thanks
Bill
http://momentoffame.com/photopost/da..._Plate-med.JPG
http://momentoffame.com/photopost/da..._Parts-med.JPG
http://momentoffame.com/photopost/da..._Shaft-med.JPG
http://momentoffame.com/photopost/da..._Cover-med.JPG
http://momentoffame.com/photopost/da..._Drive-med.JPG